Default Password for Actiontec T1200H Router

To get access to Actiontec T1200H router, you need the login IP address of your router, the username, and password.

You can find these data in Actiontec T1200H router manual. But if you lost it, then you can use the quick guide below.

Login to the Actiontec T1200H Router

The Actiontec T1200H has a web interface for configuration. You can use any web browser to log in to the Actiontec T1200H router.

Put the IP Address(without “http://” or “https://”) of your Actiontec T1200H in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Actiontec T1200H login data.

Default login data for Actiontec T1200H

You need to know the username and password to log in to your Actiontec T1200H router. We listed below.

Model Ip Username & Password
Actiontec T1200H 192.168.1.254 Username:admin/ Password:printed on router

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Actiontec T1200H Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Actiontec T1200H Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Actiontec T1200H router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Actiontec T1200H Router To Default Settings?

If you can’t get logged in, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Actiontec T1200H Default Wifi Name (SSID)

By default, some Actiontec T1200H routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Actiontec T1200H

MAC filtering allows you to restrict access to your Actiontec T1200H router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Actiontec T1200H router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.254 on the address.
  2. Enter the username and password for Actiontec T1200H router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

8 + thirteen =