Default Password for Aztech WL230USB Router

To get access to Aztech WL230USB router, you need the login IP address of your router, the username, and password.

You can find these data in Aztech WL230USB router manual. But if you lost it, then you can use the quick guide below.

Login to the Aztech WL230USB Router

The Aztech WL230USB has a web interface for configuration. You can use any web browser to log in to the Aztech WL230USB router.

Put the Internal IP Address of your Aztech WL230USB in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Aztech WL230USB login data.

Default login data for Aztech WL230USB

You need to know the username and password to log in to your Aztech WL230USB router. We listed below.

Model Ip Username & Password
Aztech WL230USB 192.168.1.1 Username:admin/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Aztech WL230USB Login Problems

If you can not get a login to your router, here are a few possible solutions you can try.

The Password of Aztech WL230USB Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Aztech WL230USB router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Aztech WL230USB Router To Default Settings?

If you still can not access the router’s setup page, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Aztech WL230USB Default Wifi Name (SSID)

By default, some Aztech WL230USB routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Aztech WL230USB

MAC filtering allows you to restrict access to your Aztech WL230USB router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Aztech WL230USB router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.1 on the address.
  2. Enter the username and password for Aztech WL230USB router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

15 − 10 =