Default Password for Cisco WRVS4400N Router

To get access to Cisco WRVS4400N router, you need the login IP address of your router, the username, and password.

You can find these data in Cisco WRVS4400N router manual. But if you lost it, then you can use the quick guide below.

Login to the Cisco WRVS4400N Router

The Cisco WRVS4400N has a web interface for configuration. You can use any web browser to log in to the Cisco WRVS4400N router.

Put the IP Address(without “http://” or “https://”) of your Cisco WRVS4400N in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Cisco WRVS4400N login infomation.

Default login data for Cisco WRVS4400N

You need to know the username and password to log in to your Cisco WRVS4400N router. We listed below.

Model Ip Username & Password
Cisco WRVS4400N 192.168.1.1 Username:admin/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Cisco WRVS4400N Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Cisco WRVS4400N Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Cisco WRVS4400N router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Cisco WRVS4400N Router To Default Settings?

If you still can’t get logged in, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Cisco WRVS4400N Default Wifi Name (SSID)

By default, some Cisco WRVS4400N routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Cisco WRVS4400N

MAC filtering allows you to restrict access to your Cisco WRVS4400N router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Cisco WRVS4400N router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.1 on the address.
  2. Enter the username and password for Cisco WRVS4400N router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

5 × two =