Default Password for Dlink DAP-1555-Bridge-Mode Router

To get access to Dlink DAP-1555-Bridge-Mode router, you need the login IP address of your router, the username, and password.

You can find these info in Dlink DAP-1555-Bridge-Mode router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Dlink DAP-1555-Bridge-Mode Router

The Dlink DAP-1555-Bridge-Mode has a web interface for configuration. You can use any web browser to log in to the Dlink DAP-1555-Bridge-Mode router.

Put the Internal IP Address of your Dlink DAP-1555-Bridge-Mode in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DAP-1555-Bridge-Mode login infomation.

Default login data for Dlink DAP-1555-Bridge-Mode

You need to know the username and password to log in to your Dlink DAP-1555-Bridge-Mode router. We listed below.

Model Ip Username & Password
Dlink DAP-1555-Bridge-Mode 192.168.0.50 Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DAP-1555-Bridge-Mode Login Problems

If you can’t get a login to your router, here are some possible solutions you can try.

The Password of Dlink DAP-1555-Bridge-Mode Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Dlink DAP-1555-Bridge-Mode router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Dlink DAP-1555-Bridge-Mode Router To Default Settings?

If you still can not access the router’s setup page, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DAP-1555-Bridge-Mode Default Wifi Name (SSID)

By default, some Dlink DAP-1555-Bridge-Mode routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DAP-1555-Bridge-Mode

MAC filtering allows you to restrict access to your Dlink DAP-1555-Bridge-Mode router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DAP-1555-Bridge-Mode router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.50 on the address.
  2. Enter the username and password for Dlink DAP-1555-Bridge-Mode router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

10 − 7 =