Default Password for Dlink DCS-3220G Router

To get access to Dlink DCS-3220G router, you need the login IP address of your router, the username, and password.

You can find these information in Dlink DCS-3220G router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Dlink DCS-3220G Router

The Dlink DCS-3220G has a web interface for configuration. You can use any web browser to log in to the Dlink DCS-3220G router.

Put the Login IP Address of your Dlink DCS-3220G in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DCS-3220G login data.

Default login data for Dlink DCS-3220G

You need to know the username and password to log in to your Dlink DCS-3220G router. We listed below.

Model Ip Username & Password
Dlink DCS-3220G 192.168.0.99 Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DCS-3220G Login Problems

If you not be able to get a login to your router, here are a few possible solutions you can try.

The Password of Dlink DCS-3220G Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Dlink DCS-3220G router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Dlink DCS-3220G Router To Default Settings?

If you can’t login the setup page of router, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DCS-3220G Default Wifi Name (SSID)

By default, some Dlink DCS-3220G routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DCS-3220G

MAC filtering allows you to restrict access to your Dlink DCS-3220G router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DCS-3220G router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.99 on the address.
  2. Enter the username and password for Dlink DCS-3220G router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

three × 5 =