Default Password for Dlink DGS-1248T Router

To get access to Dlink DGS-1248T router, you need the login IP address of your router, the username, and password.

You can find these data in Dlink DGS-1248T router manual. But if you lost it, then you can use the quick guide below.

Login to the Dlink DGS-1248T Router

The Dlink DGS-1248T has a web interface for configuration. You can use any web browser to log in to the Dlink DGS-1248T router.

Put the Login IP Address of your Dlink DGS-1248T in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DGS-1248T login data.

Default login data for Dlink DGS-1248T

You need to know the username and password to log in to your Dlink DGS-1248T router. We listed below.

Model Ip Username & Password
Dlink DGS-1248T 192.168.0.1 Username:(none)/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DGS-1248T Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Dlink DGS-1248T Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Dlink DGS-1248T router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Dlink DGS-1248T Router To Default Settings?

If you can’t login the setup page of router, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 5 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DGS-1248T Default Wifi Name (SSID)

By default, some Dlink DGS-1248T routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DGS-1248T

MAC filtering allows you to restrict access to your Dlink DGS-1248T router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DGS-1248T router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Dlink DGS-1248T router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

3 + ten =