Default Password for Dlink DIR-866L Router

To get access to Dlink DIR-866L router, you need the login IP address of your router, the username, and password.

You can find these data in Dlink DIR-866L router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Dlink DIR-866L Router

The Dlink DIR-866L has a web interface for configuration. You can use any web browser to log in to the Dlink DIR-866L router.

Put the Internal IP Address of your Dlink DIR-866L in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DIR-866L login username & password.

Default login data for Dlink DIR-866L

You need to know the username and password to log in to your Dlink DIR-866L router. We listed below.

Model Ip Username & Password
Dlink DIR-866L 192.168.0.1 Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DIR-866L Login Problems

If you can not get a login to your router, here are a few possible solutions you can try.

The Password of Dlink DIR-866L Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Dlink DIR-866L router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Dlink DIR-866L Router To Default Settings?

If you can not access the router’s setup page, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DIR-866L Default Wifi Name (SSID)

By default, some Dlink DIR-866L routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DIR-866L

MAC filtering allows you to restrict access to your Dlink DIR-866L router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DIR-866L router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Dlink DIR-866L router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

fifteen − 6 =