Default Password for Dlink DSL-500Gv4 Router

To get access to Dlink DSL-500Gv4 router, you need the login IP address of your router, the username, and password.

You can find these information in Dlink DSL-500Gv4 router manual. But if you lost it, then you can use the quick guide below.

Login to the Dlink DSL-500Gv4 Router

The Dlink DSL-500Gv4 has a web interface for configuration. You can use any web browser to log in to the Dlink DSL-500Gv4 router.

Put the Login IP Address of your Dlink DSL-500Gv4 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DSL-500Gv4 login username & password.

Default login data for Dlink DSL-500Gv4

You need to know the username and password to log in to your Dlink DSL-500Gv4 router. We listed below.

Model Ip Username & Password
Dlink DSL-500Gv4 10.1.1.1 Username:admin/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DSL-500Gv4 Login Problems

If you can not get a login to your router, here are a few possible solutions you can try.

The Password of Dlink DSL-500Gv4 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Dlink DSL-500Gv4 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Dlink DSL-500Gv4 Router To Default Settings?

If you can not access the router’s setup page, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DSL-500Gv4 Default Wifi Name (SSID)

By default, some Dlink DSL-500Gv4 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DSL-500Gv4

MAC filtering allows you to restrict access to your Dlink DSL-500Gv4 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DSL-500Gv4 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 10.1.1.1 on the address.
  2. Enter the username and password for Dlink DSL-500Gv4 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

16 − eleven =