Default Password for Dlink DSR-500N Router

To get access to Dlink DSR-500N router, you need the login IP address of your router, the username, and password.

You can find these data in Dlink DSR-500N router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Dlink DSR-500N Router

The Dlink DSR-500N has a web interface for configuration. You can use any web browser to log in to the Dlink DSR-500N router.

Put the Login IP Address of your Dlink DSR-500N in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DSR-500N login infomation.

Default login data for Dlink DSR-500N

You need to know the username and password to log in to your Dlink DSR-500N router. We listed below.

Model Ip Username & Password
Dlink DSR-500N 192.168.0.1 Username:admin/ Password:admin

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DSR-500N Login Problems

If you can’t get a login to your router, here are some possible solutions you can try.

The Password of Dlink DSR-500N Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Dlink DSR-500N router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Dlink DSR-500N Router To Default Settings?

If you can’t access the router’s setup page, then you have to reset your router to its factory settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DSR-500N Default Wifi Name (SSID)

By default, some Dlink DSR-500N routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DSR-500N

MAC filtering allows you to restrict access to your Dlink DSR-500N router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DSR-500N router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Dlink DSR-500N router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

twenty − 12 =