Default Password for Dlink DWL-G800AP Router

To get access to Dlink DWL-G800AP router, you need the login IP address of your router, the username, and password.

You can find these data in Dlink DWL-G800AP router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Dlink DWL-G800AP Router

The Dlink DWL-G800AP has a web interface for configuration. You can use any web browser to log in to the Dlink DWL-G800AP router.

Put the IP Address(without “http://” or “https://”) of your Dlink DWL-G800AP in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Dlink DWL-G800AP login data.

Default login data for Dlink DWL-G800AP

You need to know the username and password to log in to your Dlink DWL-G800AP router. We listed below.

Model Ip Username & Password
Dlink DWL-G800AP 192.168.0.30 Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Dlink DWL-G800AP Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Dlink DWL-G800AP Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Dlink DWL-G800AP router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Dlink DWL-G800AP Router To Default Settings?

If you still can not login the setup page of router, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Dlink DWL-G800AP Default Wifi Name (SSID)

By default, some Dlink DWL-G800AP routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Dlink DWL-G800AP

MAC filtering allows you to restrict access to your Dlink DWL-G800AP router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Dlink DWL-G800AP router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.30 on the address.
  2. Enter the username and password for Dlink DWL-G800AP router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

nineteen − 11 =