Default Password for Netcomm NB1300 PLUS 4 Router

To get access to Netcomm NB1300 PLUS 4 router, you need the login IP address of your router, the username, and password.

You can find these data in Netcomm NB1300 PLUS 4 router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Netcomm NB1300 PLUS 4 Router

The Netcomm NB1300 PLUS 4 has a web interface for configuration. You can use any web browser to log in to the Netcomm NB1300 PLUS 4 router.

Put the IP Address(without “http://” or “https://”) of your Netcomm NB1300 PLUS 4 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netcomm NB1300 PLUS 4 login infomation.

Default login data for Netcomm NB1300 PLUS 4

You need to know the username and password to log in to your Netcomm NB1300 PLUS 4 router. We listed below.

Model Ip Username & Password
Netcomm NB1300 PLUS 4 192.168.1.1 Username:admin/ Password:password

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netcomm NB1300 PLUS 4 Login Problems

If you can’t get a login to your router, here are some possible solutions you can try.

The Password of Netcomm NB1300 PLUS 4 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netcomm NB1300 PLUS 4 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Netcomm NB1300 PLUS 4 Router To Default Settings?

If you can’t access the router’s setup page, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Netcomm NB1300 PLUS 4 Default Wifi Name (SSID)

By default, some Netcomm NB1300 PLUS 4 routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netcomm NB1300 PLUS 4

MAC filtering allows you to restrict access to your Netcomm NB1300 PLUS 4 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netcomm NB1300 PLUS 4 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.1 on the address.
  2. Enter the username and password for Netcomm NB1300 PLUS 4 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

six − 5 =