Default Password for Netgear DG632 Router

To get access to Netgear DG632 router, you need the login IP address of your router, the username, and password.

You can find these data in Netgear DG632 router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Netgear DG632 Router

The Netgear DG632 has a web interface for configuration. You can use any web browser to log in to the Netgear DG632 router.

Put the Internal IP Address of your Netgear DG632 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear DG632 login username & password.

Default login data for Netgear DG632

You need to know the username and password to log in to your Netgear DG632 router. We listed below.

Model Ip Username & Password
Netgear DG632 192.168.0.1 Username:admin/ Password:password

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear DG632 Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Netgear DG632 Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netgear DG632 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Netgear DG632 Router To Default Settings?

If you still can’t access the router’s setup page, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 10 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear DG632 Default Wifi Name (SSID)

By default, some Netgear DG632 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear DG632

MAC filtering allows you to restrict access to your Netgear DG632 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear DG632 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Netgear DG632 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

2 × four =