Default Password for Netgear VMDG490 Router

To get access to Netgear VMDG490 router, you need the login IP address of your router, the username, and password.

You can find these data in Netgear VMDG490 router manual. But if you lost it, then you can use the quick guide below.

Login to the Netgear VMDG490 Router

The Netgear VMDG490 has a web interface for configuration. You can use any web browser to log in to the Netgear VMDG490 router.

Put the Internal IP Address of your Netgear VMDG490 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear VMDG490 login username & password.

Default login data for Netgear VMDG490

You need to know the username and password to log in to your Netgear VMDG490 router. We listed below.

Model Ip Username & Password
Netgear VMDG490 192.168.0.1 Username:none/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear VMDG490 Login Problems

If you can not get a login to your router, here are some possible solutions you can try.

The Password of Netgear VMDG490 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netgear VMDG490 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Netgear VMDG490 Router To Default Settings?

If you can not get logged in, then you have to reset your router to its default settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear VMDG490 Default Wifi Name (SSID)

By default, some Netgear VMDG490 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear VMDG490

MAC filtering allows you to restrict access to your Netgear VMDG490 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear VMDG490 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Netgear VMDG490 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

six + 10 =