Default Password for Netgear WG102 Router

To get access to Netgear WG102 router, you need the login IP address of your router, the username, and password.

You can find these information in Netgear WG102 router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Netgear WG102 Router

The Netgear WG102 has a web interface for configuration. You can use any web browser to log in to the Netgear WG102 router.

Put the IP Address(without “http://” or “https://”) of your Netgear WG102 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear WG102 login data.

Default login data for Netgear WG102

You need to know the username and password to log in to your Netgear WG102 router. We listed below.

Model Ip Username & Password
Netgear WG102 192.168.0.229 Username:admin/ Password:password

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear WG102 Login Problems

If you can not get a login to your router, here are some possible solutions you can try.

The Password of Netgear WG102 Doesn’t Work

It would be best if you tried the other same brands’ passwords.

Perhaps your router’s default password is differs from what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netgear WG102 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Netgear WG102 Router To Default Settings?

If you still can not login the setup page of router, then you are probably going to reset your router to its factory settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear WG102 Default Wifi Name (SSID)

By default, some Netgear WG102 routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear WG102

MAC filtering allows you to restrict access to your Netgear WG102 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear WG102 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.0.229 on the address.
  2. Enter the username and password for Netgear WG102 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

eleven + 3 =