Default Password for Netgear WNDR4300SW Router

To get access to Netgear WNDR4300SW router, you need the login IP address of your router, the username, and password.

You can find these info in Netgear WNDR4300SW router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Netgear WNDR4300SW Router

The Netgear WNDR4300SW has a web interface for configuration. You can use any web browser to log in to the Netgear WNDR4300SW router.

Put the IP Address(without “http://” or “https://”) of your Netgear WNDR4300SW in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Netgear WNDR4300SW login username & password.

Default login data for Netgear WNDR4300SW

You need to know the username and password to log in to your Netgear WNDR4300SW router. We listed below.

Model Ip Username & Password
Netgear WNDR4300SW Username:admin/ Password:password

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Netgear WNDR4300SW Login Problems

If you not be able to get a login to your router, here are a few possible solutions you can try.

The Password of Netgear WNDR4300SW Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the label of the router.

What if forgot password to Netgear WNDR4300SW router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Netgear WNDR4300SW Router To Default Settings?

If you can not login the setup page of router, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 8 seconds. It may be an aperture or a button and will be clearly marked.

Change Netgear WNDR4300SW Default Wifi Name (SSID)

By default, some Netgear WNDR4300SW routers have network names (with the manufacturer name). We recommend using a special name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Netgear WNDR4300SW

MAC filtering allows you to restrict access to your Netgear WNDR4300SW router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Netgear WNDR4300SW router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the on the address.
  2. Enter the username and password for Netgear WNDR4300SW router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.


Leave a comment

Your email address will not be published.

1 × 3 =