Default Password for Sitecom X3 N300 Router

To get access to Sitecom X3 N300 router, you need the login IP address of your router, the username, and password.

You can find these data in Sitecom X3 N300 router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Sitecom X3 N300 Router

The Sitecom X3 N300 has a web interface for configuration. You can use any web browser to log in to the Sitecom X3 N300 router.

Put the Internal IP Address of your Sitecom X3 N300 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Sitecom X3 N300 login data.

Default login data for Sitecom X3 N300

You need to know the username and password to log in to your Sitecom X3 N300 router. We listed below.

Model Ip Username & Password
Sitecom X3 N300 Username:admin/ Password:(none)

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Sitecom X3 N300 Login Problems

If you not be able to get a login to your router, here are some possible solutions you can try.

The Password of Sitecom X3 N300 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Sitecom X3 N300 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login data are, or maybe they can reset it for you.

How to Reset the Sitecom X3 N300 Router To Default Settings?

If you can’t login the setup page of router, then you have to reset your router to its factory settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Sitecom X3 N300 Default Wifi Name (SSID)

By default, some Sitecom X3 N300 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Sitecom X3 N300

MAC filtering allows you to restrict access to your Sitecom X3 N300 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Sitecom X3 N300 router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the on the address.
  2. Enter the username and password for Sitecom X3 N300 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.


  1. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

2 × 3 =