Default Password for Telstra Smart Modem Gen 2 Router

To get access to Telstra Smart Modem Gen 2 router, you need the login IP address of your router, the username, and password.

You can find these data in Telstra Smart Modem Gen 2 router manual. But if you do not want to read the whole manual to find the default login information, then you can use the quick guide below.

Login to the Telstra Smart Modem Gen 2 Router

The Telstra Smart Modem Gen 2 has a web interface for configuration. You can use any web browser to log in to the Telstra Smart Modem Gen 2 router.

Put the Login IP Address of your Telstra Smart Modem Gen 2 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Telstra Smart Modem Gen 2 login infomation.

Default login data for Telstra Smart Modem Gen 2

You need to know the username and password to log in to your Telstra Smart Modem Gen 2 router. We listed below.

Model Ip Username & Password
Telstra Smart Modem Gen 2 192.168.0.1 Username:admin/ Password:Telstra

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Telstra Smart Modem Gen 2 Login Problems

If you can not get a login to your router, here are some possible solutions you can try.

The Password of Telstra Smart Modem Gen 2 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Telstra Smart Modem Gen 2 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s login information are, or maybe they can reset it for you.

How to Reset the Telstra Smart Modem Gen 2 Router To Default Settings?

If you still can’t login the setup page of router, then you have to reset your router to its factory settings.

To do this, press and hold the Reset button for 8 seconds. It may be an aperture or a button and will be clearly marked.

Change Telstra Smart Modem Gen 2 Default Wifi Name (SSID)

By default, some Telstra Smart Modem Gen 2 routers have network names (with the manufacturer name). We recommend using a different name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Telstra Smart Modem Gen 2

MAC filtering allows you to restrict access to your Telstra Smart Modem Gen 2 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Telstra Smart Modem Gen 2 router. Be sure to update this information when adding devices.

How to configure:

  1. Open the web browser and type the 192.168.0.1 on the address.
  2. Enter the username and password for Telstra Smart Modem Gen 2 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

  1. While I searched all over the world for the default password of this damn router, I find it here.

  2. While I searched all over the world for the default password of this damn router, I find it here.

Leave a comment

Your email address will not be published.

ten − 8 =