Default Password for Westell Wirespeed 2410 Router

To get access to Westell Wirespeed 2410 router, you need the login IP address of your router, the username, and password.

You can find these info in Westell Wirespeed 2410 router manual. But if you do not have the manual for your router, then you can use the quick guide below.

Login to the Westell Wirespeed 2410 Router

The Westell Wirespeed 2410 has a web interface for configuration. You can use any web browser to log in to the Westell Wirespeed 2410 router.

Put the IP Address(without “http://” or “https://”) of your Westell Wirespeed 2410 in the Address Bar of your web browser. Then press the Enter key on your keyboard. You should see a dialog box pop up asking you for your Westell Wirespeed 2410 login username & password.

Default login data for Westell Wirespeed 2410

You need to know the username and password to log in to your Westell Wirespeed 2410 router. We listed below.

Model Ip Username & Password
Westell Wirespeed 2410 192.168.1.1 Username:NOLOGIN/ Password:NOLOGIN

Note: If you are using the default settings you should change them to increase security and prevent unauthorized access to your network.

Other Westell Wirespeed 2410 Login Problems

If you can’t get a login to your router, here are a few possible solutions you can try.

The Password of Westell Wirespeed 2410 Doesn’t Work

It would help if you tried the other same brands’ passwords.

Perhaps your router’s default password is different than what we have listed here.

Some Brands will set a different Complex password that is difficult to remember, and then printed on the back of the router.

What if forgot password to Westell Wirespeed 2410 router?

If your Internet Service Provider supplied you with your router then you might want to try giving them a call, and see if they either know what your router’s username and password are, or maybe they can reset it for you.

How to Reset the Westell Wirespeed 2410 Router To Default Settings?

If you still can not login the setup page of router, then you are probably going to reset your router to its default settings.

To do this, press and hold the Reset button for 7 seconds. It may be an aperture or a button and will be clearly marked.

Change Westell Wirespeed 2410 Default Wifi Name (SSID)

By default, some Westell Wirespeed 2410 routers have network names (with the manufacturer name). We recommend using a personalized name because a default name unnecessarily identifies your router’s brand, which makes it easier for hackers.

Configure Wireless MAC address filter for Westell Wirespeed 2410

MAC filtering allows you to restrict access to your Westell Wirespeed 2410 router. To enable this feature, enter the 12 digit MAC ID of each computer connected to your network into your Westell Wirespeed 2410 router. Be sure to update this information when removing devices.

How to configure:

  1. Open the web browser and type the 192.168.1.1 on the address.
  2. Enter the username and password for Westell Wirespeed 2410 router.
  3. Go to the MAC List page, you can find the MAC address of all the devices which are connected to the router.
  4. Go to Wireless->Wireless MAC Filtering page, click the Add New button.
  5. Type in the MAC address you want to allow or deny to access the router, and give a description for this item.
  6. The status should be Enabled and at last, click the Save button.
Published

3 comments

Leave a comment

Your email address will not be published.

4 × four =